Lazytown’s closing number has hit the charts in the U.K. big time. It’s only been a week, and according to the BBC, Bing Bang is at #4.

Sure the days are short, but it’s nice to be able to sleep in and still watch the sun come up.

Not that I slept in. I woke up at 3:30 this morning, thanks to jetlag. Finally got out of bed around four and wrote for about an hour. I went back to bed and was completely unable to sleep until my alarm went off. What is it about knowing that one needs to get up which causes one to become completely unconscious? Anyway, I went in with Rob to work at about 9:00 this morning. I’ve gotten good work done on the bear, but there’s still more to do.

The jaw is creating two problems; it’s contributing to the ventilation issue, because it’s solid fiberglass, so is providing a shelf that the actor’s breath bounces against, shooting it up against the eyes. It’s also not fitting one of the actors well. This bear needs to be able to fit multiple people which provides challenges, since masks are usually built to fit one person. Particularly with a mouth that’s activated by the performer’s jaw, the mask needs to fit extremely snugly. The fiberglass, while providing clean movement if well-fitted, is too big for one of the actors.

So. To start with, I created a copy of the jaw in reticulated foam. I use a brand called drifast which is designed to wick moisture away in outdoor furniture. Hopefully, this will help with the venting issues. To get really specific and uber-jargony on you, I used 1-inch DriFast with 35 ppi (pores per inch).
Next, I stitched elastic to the exterior of it, in the same place I had elastic on the original fiberglass jaw. I also added a piece across the interior, which serves to two functions. It helps the jaw retain its shape and it also acts to cup the actor’s chin.
I lined the jaw with black fabric, and covered the exterior with fur. One of the things that I love about reticulated foam is that you can stitch to it very easily and it’s tear-resistant.
Once it was all covered, I installed it in the original location. To my surprise, this has better movement than the original fiberglass. Usually you think of going rigid for mechanism, but, I’m guessing, because of this is a really snug fit it responds more quickly to the jaw’s movement. Think of it like wearing a ski mask.

Sadly, the thing still fogs, but it’s slower and not as hot so that’s movement in the right direction. I’ve been reading about defoggers for scuba divers. Most websites recommend spit. Somehow, I can’t see myself recommending spitting into a mask that’s supposed to be worn around sick children. There are actual products, so I’ll see if I can find any here.

Before anyone recommends it–there is no place to put a fan in the bear’s head and even if there were, it would not solve the humidity issue. I think we have oxygen flowing in the mask now, but the humidity is the next hurdle to deal with.

If the defogger doesn’t work, then I’ll try putting a vapor barrier between the eyes and the nose, but this will likely make it uncomfortable, so I’m trying to avoid that.

(For the puppet geeks reading this, I buy my foam here. They ship.)