Mental note: Do not try to eat an unpeeled kiwi in an area with floating polar bear fur. The two are dynamically attracted to each other.

We’ve discovered that the bear has ventilation issues. I was worried about the heat buildup in the mask before I left, but it turns out that is only part of the problem. We have more of an issue with fogging in the eyes. If you’ll recall, the eyes are made of sunglasses and the mask, despite my cutting away for the fiberglass, is still a very closed environment. There’s nowhere for the humidity that the breath carries to go because the fur is too thick to vent.

I’ve started by opening the fur over the holes in the front of the mask.
Next, I filled the hole in with a fine net.
Using small plugs of Hringur bear’s fur, I carefully place them on the net. My goal is to create the illusion that the bear is still fully furred, while allowing more air to pass into the mask.

Here it is in the finished state.

Next I’ll replace the lower jaw with a foam one, which should allow for more ventilation.